PDF to Letters

First print the 1-inch calibration sheet and check it with a ruler.

1. Join each row, left to right. On columns 2 onward, use a ruler to join the solid ticks and cut off the LEFT white border. Lay the trimmed edge ON TOP of the preceding sheet at its dashed ALIGN ticks. Keep the preceding sheet’s right overlap underneath.

2. Join the completed rows, top to bottom. On rows 2 onward, trim the TOP white border across the entire joined row. Lay it ON TOP of the preceding row at the ALIGN ticks in the far left and far right gutters. Keep the preceding row’s bottom overlap underneath.

3. Finish the outside. Only after joining everything, trim the four outside borders through every layer and tape on the back. With zero overlap, artwork edges meet at the ALIGN ticks; keep the white borders as tabs underneath. Guides never print over your artwork.

Choose one source page at a time. PDFs up to 50 MB, 200 source pages and 200 output sheets are supported. Guide marks and instructions use reserved gutters inside the printable margin. This does not shrink the artwork. If you turn guides off, no cut or alignment marks are printed.